Trailer Hitch Mounted Bike Rack Recommendation for a 2011 Subaru Outback
Question:
I would like to install Draw-Tite 75673 with a Reese Eclipse Bike Carrier 63124. Can you tell me if I will be able to open the rear cargo door of a 2011 Subaru Outback Wagon with the carrier in the tilted down position? Thank you!
asked by: Chris R
Expert Reply:
When installed on your 2011 Subaru Outback, there will be approximately 7 inches from the center of the hitch pin hole out to the rear edge of the bumper. The Swagman Original # S64400, measures 14.5 inches from hitch pin hole center to the back of the up right bar, and tilts down at about a 45 degree angle. This should be enough for you to be able to open the rear hatch on the vehicle.
This should be a good choice for you.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 600 lbs TW
- 4000 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Recommended Tire Clearance Between Tires on Dual Axle Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Strut for Stabilus Lift-O-Mat on Dometic Awning
- Q&A: Is a Master Key Needed to Install or Remove a Thule Lock Cylinder
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Can Electric Trailer Brake Kit # AKEBRK-2 be Submerged in Water
- Q&A: Battery Box that Can Fit Trailer Frame
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Article: Best Bike Racks for Electric Bikes
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)