How to Remove Side Panel Hooks when Installing the Curt T-Connector # C56158 on a 2013 Honda CR-V
Question:
I got the wiring kit for a 2013 CRV and have problems. Open the side panel to get to the wiring. The instruction say to remove screws, well there are no screws only hooks and I can not figure out how they come out. Help
asked by: Darel
Expert Reply:
I believe the place where you are stuck at for installing the Curt T-Connector # C56158 on your 2013 Honda CR-V is addressed by the installer at mark 0:35 in the attached installation video.
When our installation team member installed this same T-Connector on a similar 2013 CR-V he noted:
"To remove some of the tabs on the interior panel you will need to push the center of them and they will be able to pulled out once the center is pushed in."
If you watch the rest of the installation video it should help to make the installation go quicker.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Trailer Hitch for a 2018 Toyota RAV4 Hybrid
- Q&A: Troubleshooting Failed Hopkins Powered Taillight Converter 46255 in 2013 Toyota RAV4
- Q&A: Selecting the Correct Curt T-Connector Wiring Harness For a 2022 Ford Bronco
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Trailer Wheel Studs for a 5 on 4-1/2 UFP Hub
- Q&A: Recommended Hitch for a 2013 Honda CR-V
- Q&A: Recommended Kayak Carrier for 2 Inch Round Bar Roof Rack
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: Best Bike Racks for Electric Bikes
- Article: How Much Does a Boat and Trailer Weigh?
- Article: Trailer Wiring Diagrams
- Article: Ball Mount Basics: Weight Capacity, Class, and Size