Recommendation For a Solid Step for 2010 Keystone Cougar 5th Wheel
Question:
We are interested in the Solid Step for our 5th wheel. We have a 2010 Keystone Cougar. What one would we need?
asked by: Shaun
Expert Reply:
How well RV steps like the Lippert SolidStep Item # LC791572 fits your RV depends on the size of your trailer door opening. This SolidStep 3-step model fits doorways that are 26 inches wide to 29-7/8 inches wide where there is a threshold height of 27 inches to 36 inches from the ground.
A similar 4-step model, Item # LC791574, fits a doorway width of 26 inches wide to 29-7/8 inches wide with a ground to threshold height ranging from 35 inches to 44 inches.
I looked several places for information on travel trailer door sizes and heights and did not find a specific match for your 2010 Keystone. Generally RV manufacturers use standard sizes for things like doors. Based on the photos I found, I think one of these steps will work for you. You will just need to do some measuring to figure out which one is best for you and your situation. When doing your measuring, be sure to include the mounting hole so that you can get steps with matching holes. Since Lippert manufactures most of the trailer frames and aftermarket products, one of these should be a good fit.
If you send me your current mounting hole dimensions, I can make a specific recommendation.
Brian S.
2/23/2020
I have a 2009 Keystone Cougar it has a landing height of 35 1/2 and the entry door is 24 have a 3/8 height difference between floor and threshold what model lippert solid step will I need?? Not much of a gap between screen door and trim will that matter??
Products Referenced in This Question
Lippert SolidStep RV Steps for 25" to 28-7/8" Wide Doorways - 4 Steps
- RV Steps
- Towable Camper
- Fold-Down Step
- 20 Inch Wide Step
- 22-1/2 Inch Wide
- 4 Steps
- 8 Inch Drop/Rise
- Ground Contact
- Aluminum
- Lippert
more information >
Product Page this Question was Asked From
Lippert SolidStep RV Steps for 25" to 28-7/8" Wide Doorways - 3 Steps
- RV Steps
- Towable Camper
- Fold-Down Step
- 20 Inch Wide Step
- 22-1/2 Inch Wide
- 3 Steps
- 8 Inch Drop/Rise
- Ground Contact
- Aluminum
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: access door
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Smallest Size Doorway Opening for SolidStep Manual Fold-Down Steps LC791572
- Q&A: How to Choose Correct Width Lippert Solid Step Folding RV Steps
- Q&A: Will Torklift TLD2142 Fit 2019 Ram 3500 With Running Boards Extending Under Bed
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: What Might Cause Lippert SolidStep to Make Shutting Door Difficult
- Q&A: Does Lippert Stabilizer Jack LC298707 Fit Grand Design Transcent 245RL
- Article: Trailer Tire Sizing
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Should I Choose The 3 or 4 Step SolidStep For my Jayco Eagle with 29-1/4" Door Way
- Q&A: Differences Between the Lippert Components Power Stabilizer Trailer Jacks
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Gooseneck to 5th Wheel Adapters
Brian S.
2/26/2020
So I ordered a 24 inch solid step dare watching videos to install it looks like I should have measured the length of the entire door and not inside flange to inside flange will this mean the stairs wont work cuz I went from inside to inside to get my 24 in measurement I was given bad information from a camping supply store outside of etrailer on how to take measurements for the stairs will the 24 in stair work or does it have to be the width from the widest point of the door to the widest point of the door