Diameter of Opening in Bracket of Hopkins Endurance # HM48470
Question:
What is the hole diameter for a Hopkins HM48470 trailer light wire connector? Im trying to relocate mine and need to cut a hole in the bracket for it. Thanks
asked by: Vito A
0
Expert Reply:
It sounds like you're looking for the diameter of the hole in the bracket that is included with the Hopkins # HM48470. I went out to our warehouse and took the measurement. It's about 2-1/8 inches.
If you're looking for a different measurement let me know and I'll find the correct answer for you.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Hopkins Endurance Multi-Tow 7-, 5- and 4-Way Flat Trailer Connector - Vehicle End - Ergonomic Design
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 4 Flat
- 5 Flat
- 7 Blade
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Does HBA-CAM Adapter Module for Hydrastar Electric Over Hydraulic Brake Actuators have 2 or 4 Wires
- Article: What is Overlanding? How to Start your Overlanding Journey
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Q&A: How Many Transfer Switches are Needed to Switch from Shore Power to a Genreator, and An Inverter?
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Article: Trailer Maintenance Schedule
- Q&A: Selection of Special Trailer Tires for 5th Wheel Trailer to Avoid Blowouts
- Q&A: Replacement Brake Assemblies and Hub/Drums for 15k Dexter Axle
- Q&A: Will Coil SumoSprings Custom Helper Springs Fit a 2018 Toyota Highlander
- Article: RV Cell Boosters, How Do They Work?
- Article: Top Gifts for Dads in 2024
- Article: Trailer Wiring Diagrams
- Article: Replacement Automotive Lighting
- Article: Trailer Tire Sizing