How to Install the Rampage SuperBrite LED Tailgate Light Bar Part # RA960137
Question:
What degree of weather does it have to be to install this light bar?
asked by: Harley
Expert Reply:
The Rampage SuperBrite LED Tailgate Light Bar part # RA960137 can be installed in pretty much any weather that your fingers can still function in. There is not a maximum or minimum temperature range for installation of this product.
All you really need to do to install the light would be first clean the surface you are attaching it to and then carefully take the tape off the back of the adhesive while aligning it between the opening of your tailgate and bumper. Once the light is in place you will want to press and hold firmly for a few minutes. The wires can then be routed to the 4-way trailer connector and secured to the frame using zip ties.
Product Page this Question was Asked From
Rampage SuperBrite LED Tailgate Light Bar - Stop, Tail, Turn, Reverse - 4-Pole Flat - 49" Long
- Vehicle Lights
- Accent Light
- Tailgate Bar
- Single Light
- LED Light
- Light Assembly
- Strip
- Red/White
- Rampage
more information >
Continue Researching
- Article: Trailer Maintenance Schedule
- Article: How to Charge a Dump Trailer Battery
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Mobile Home Axle Conversion to Electric Trailer Brakes
- Q&A: What Stops Porpoising on Tow Vehicle that is Using Weight Distribution with Trailer
- Q&A: Trailer Grease Seal to Replace 127194TB
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Q&A: 205/75R14 Size Trailer Tire Needed with Load Range D and Speed Rating of at Least 81 mph
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams