Inner and Outer Diameter of Fittings on Valterra Bladex Waste Valve # T1002A
Question:
Is it Schedule 40 size or class 200?
asked by: Floyd
0
Expert Reply:
The two things you mentioned refer to the wall thickness of PVC. So to answer that question the # T1002A that you referenced has an inner diameter of 2 inches and an outer diameter of 2-3/8 inches on both sides.
For more info check out the review video I attached for this as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Bladex Waste Valve for RV Holding Tank - 2" Diameter - Spigot to Spigot
- RV Waste Valves
- Straight Valve
- Single Waste Valve - Manual
- 2 Inch Valve Body
- Stationary Valve
- Valterra
more information >
Continue Researching
- Shop: Valterra Bladex Waste Valve for RV Holding Tank - 2" Diameter - Hub to Hub
- Shop: Valterra Bladex Waste Valve for RV Holding Tank - 2" Diameter - Spigot to Spigot
- Q&A: Recommended Solution to Bolt on Safety Chains to Utility Trailer
- Q&A: Understanding Difference Between Hubs and Spigots for RV Waste Valves
- Q&A: What is Difference Between RV Waste Valves Hubs and Spigots
- Q&A: How to Install the Air Lift Kit part # AL57338 in a Vehicle with Gooseneck/Fifth Wheel Hitch
- Q&A: Replacement Slide-Out Motor for Power Gear 523725
- Q&A: Replacement Gray Water Valve for Valterra System with 2 Inch Diameter Pipe
- Q&A: Recommended Replacement For An Atwood G6A-8E RV Water Heater
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule