Wiring Reverse Light Circuit to 7 Way Connector on 2016 GMC Terrain
Question:
I am installing a 7 pin connector to my 2016 GMC Terrain. Which wire on the vehicle do I connect the reverse light pin to? Also Can I connect the Aux Power pin to the rear 12 outlet rather than making additional run to the battery?
asked by: Henry
Expert Reply:
The center pin of a 7-way is typically the reverse light circuit. You'd need to tap into the reverse light circuit of your 2016 GMC Terrain to activate it.
For a quick splice for 14-18 gauge wire you'd want # SWC501746-1 or for 10-12 gauge wire # SWC501915-1.
I'd recommend strongly that you run the 12 volt power wire back to the positive post of the battery and not to a 12 volt outlet to prevent shorting out that circuit.
Products Referenced in This Question
Quick Splices - Self-Stripping Connector - Closed Port - 10-12 Gauge - Yellow - Qty 1
- Wiring
- Wire Connectors
- Quick Splice Connectors
- 12-10 Gauge
- Spectro
more information >
Product Page this Question was Asked From
Self-Stripping Connector with Waterproof Sealant - 14-18 Gauge - White and Blue - Qty 1
- Wiring
- Wire Connectors
- Quick Splice Connectors
- 18-14 Gauge
- Spectro
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Basics of Tie-Down Chains and Binders
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacing A 125255UC Double Lip Grease Seal
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Q&A: Recommended Replacement Master Cylinder for a TCIC 23361
- Q&A: Replacement Master Cylinder for DICO 189
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Do Hubs Need to be Replaced When Replacing Trailer Brakes
- Q&A: How to Fix a Pitted Spindle
- Q&A: How To Raise a Keystone Outback Trailer with Tandem 3 Inch Axles
- Article: How to Measure Your Trailer Wheel Bolt Pattern