How to Determine if Rhino Rack Roof Basket Will Fit Factory Crossbar of 2011 Toyota Sienna

Question

Question:

I need to know if this Rhino basket v#RMCCB02 will work on a 2011 Toyota Sienna that has the factory installed roof system including cross bars.

asked by: Richard B

0

Expert Reply:

Here's how you'll be able to know if the Rhino Rack roof basket will fit the factory crossbars of your 2011 Toyota Sienna. You'll need to measure your roof rack and if the bars are less than 3-1/2 inches wide and 1-1/4 inch tall and between 25-1/2 and 43 inches apart this will fit them well.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 5

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 6

The Large Yakima OffGrid #Y07139 Cargo Basket uses crossbar clamps that are designed to be universal. They will fit virtually any crossbar shape, including most aftermarket and OEM crossbars. I was not able to find any schematics online that would…

view full answer...

Answer 7

The Replacement Clamp #RRSP112 is a single clamp for the Rhino-Rack Roof Mounted Steel Cargo Basket #RMCB. Included is the clamp, screws, and all parts to secure the basket at one point to your crossbar.

view full answer...

Answer 8

I attached a picture of the larger Rhino Rack Cargo Basket part #RMCB02 installed on a customer of ours 2013 Outback which is very similar to your 2015. You can see that it fits the roof actually really well. It wouldn't look oversized at all on…

view full answer...

Answer 9

The rubber pads for the Rhino-Rack XTray Clamp Set unfortunately are not sold separately so you would either need to reach out to Rhino-Rack to see if they could ship you them or purchase a replacement clamp set #RRSP112.

view full answer...

Answer 10

Hey Tami, so since your 2021 Toyota Highlander has the flush mount rails, your only option for adding a cargo basket will be to first add a roof rack with crossbars. I suggest going with a Rhino Rack Aero Bar roof rack, which will consist of the…

view full answer...

How to Determine if Rhino Rack Roof Basket Will Fit Factory Crossbar of 2011 Toyota Sienna

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching