Which Pin on Trailer 6-Way Carries 12 Volt Accessory Circuit
Question:
does the black wire with power in it go to the center pin on the six way. and does the blue wire suppose to have power in it at the pin coming from the controller , thanks
asked by: Steve
Expert Reply:
The center pin of a 6-way does carry the 12 volt accessory circuit like you described. The brake controller output circuit would then be the pin in the 10:00 position like what you see in the diagram attached.
You should note that in some cases these two circuits are switched and are opposite of the diagram. Since this is a pretty common issue that frustrates people and you asked specifically about those two circuits on a 6-way I figured it was worth mentioning.
Product Page this Question was Asked From
Pollak 6-Pole, Round Pin, Trailer Wiring Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Continue Researching
- Article: Top Gifts for Dads in 2024
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: Should the Tires Lift Off the Ground While Leveling With the Lippert Ground Control Leveling System
- Q&A: Does Lippert Spare Tire Winch Lock or Hold in Any Position?
- Q&A: Weight Capacity Of Lippert Spare Tire Winch For Over sized Tire
- Q&A: How Does Lippert Components Spare Tire Winch with Offset Cable Crank Up and Down
- Q&A: How To Tell If Bearing Buddy Has Enough Grease
- Q&A: How is Lippert Spare Tire Winch LC159056 Raised and Lowered
- Q&A: Inside Diameter of Replacement Crank Extension for Lippert Spare Tire Winch Assemblies
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose a High-Low Adapter
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)