5th Wheel Trailer Rides High in the Front with Andersen Ultimate Hitch in 2015 Ram 2500
Question:
1. With the Andersen hitch ball in the bottom hole extended at highest = 5inch to 6inch clearance top of bed rails to bottom of our 2010 Montana 3750FL = OK 2. The 3750FL sits front high = Not OK 3. So high ....the hitch ball angle created makes detachment difficult after arriving at our destination.
asked by: Mike B
Expert Reply:
Since you are currently at the appropriate 5-6 inches of clearance between the underside of the trailer and the tops of the bed sides the only other thing you can do to level the trailer is to raise the height at the back. For that you might be able to use an over/under conversion kit if:
The trailer leaf spring stack is currently mounted under the axles
The trailer uses double-eye springs
And the trailer has 2-3/8 inch or 3 inch diameter round axles
For a 2-3/8 inch round axle use # K71-384-00 and for a 3 inch diameter axle use # K71-385-00.
If you cannot use an over/under conversion kit then the only other way to raise the height of the trailer is to have the old suspension hangers cut off and new, taller ones welded on by a qualified professional welder. I have included a link to the hanger main page for you.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions for the MORryde ALLTREK 4000 Suspension Kit
- Q&A: Double Eye Leaf Springs For Tandem Axle Trailer With 10,500LB Rating and 24" Length on Spring
- Q&A: Does MORryde ALLTREK 4000 Cushioned Equalizer Sit Taller to Offset for Additiona Suspension Movement
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Q&A: What Leaf Spring Width SHould be Used with Dexter Over Under Kit # K71-384-00
- Q&A: Would Dexter 3,500 lb Axle Made in 1999 Use Same Hubs as Current