Installing a Tekonsha Prodigy Brake Controller on a 2017 Nissan Titan

Question:

Does the break controller harness connection under the dashboard of the Nissan Titan 2017 SV connect to the 7 pin connector in the rear of truck at the hitch at the break connection for the trailer? if so then connecting a Prodigy brake controller to this harness should complete the installation to the 7 pin RV connector?

asked by: Jim J

Expert Reply:

To install a brake controller like the Tekonsha Prodigy P3 # 90195 in your 2017 Nissan Titan you will simply need the Tekonsha Plug-In Wiring Adapter # 3050-P.

The adapter will connect to a harness that is located underneath and left of the steering column. It should be taped to another harness near the emergency brake pedal per the linked instructions.

Once the brake controller is installed you should be good to go since you have the factory 7-Way. If you didn't have the factory 7-Way you would just need to check to see if the proper relays are installed. If they were not, you would just need the Curt Relay Kit # C57000 and possibly a 3rd blue relay requiring a second Relay Kit # C57000 to activate the tow package.

I have attached some videos for you to reference as well as the installation instructions.