Can the etrailer Single Axle Trailer Fender # HP29VR be Screwed on Instead of Welded
Question:
This shows as a weld on. Can it be screwed on also?
asked by: Linard M
Helpful Expert Reply:
If you are okay with putting some screws through the Single Axle Trailer Fender # HP29VR that can secure it for travel then I see no reason why not.
It is classified as a weld-on application because there are no places that have been made for screws so you will have to install them through the finish which may not look as great as a weld-on installation would. I recommend securing it in at least 3 places if you go this route; both of the sides and one in the middle.
Product Page this Question was Asked From
Single Axle Trailer Fender for Enclosed Trailers - Cold Rolled Steel - 15" Wheels - Qty 1
- Trailer Fenders
- No Step
- 15 Inch Wheels
- 10-3/4 Inch Wide
- 32 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Fender Installation Clearance and Mounting Project
- Q&A: Recommended Replacement Fender For A 2018 Forest Rover R-Pod RP-179
- Q&A: Correct Replacement for Advent Analog Wall Thermostat ACTH1
- Article: Most Popular Wheel Bearings
- Q&A: Trailer Fender Close to 29-1/2" Long, 13" Tall & 9-1/2" Wide
- Q&A: Availability of 11 x 32 x 15 Inch Fenders for Single-AxleTrailer
- Q&A: Replacement Cover for Trailer Roof Vent AS-13 M-VD0449
- Q&A: How Long Do Leaf Spring Bushings Last
- Article: Trailer Lighting Requirements
- Article: Trailer Tire Sizing
- Article: Where to Position the Trailer Axle?
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule