Are Trailer Breakaway System Supposed to Lock Up Trailer Brakes when Activated
Question:
Is brake a way switch suppose to lock up the brakes. When you press leaver on control box is it suppose to stop your trailer.
asked by: Don J
0
Expert Reply:
Yes, a trailer breakaway system like the # 20099 is designed to apply the maximum amount of braking power to the trailer brakes when activated so the brakes should lock up.
I attached a couple help articles on breakaway systems for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hopkins Engager Push-To-Test Trailer Breakaway Kit w/ Built-In Charger - Side Load - 7" Wire
- Trailer Breakaway Kit
- Kit with Charger
- Side Load
- Single-axle
- Tandem-axle
- LED Tester
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing Dexter DX, BrakeRite II, and Hydrastar Electric-Over-Hydraulic Actuators
- Article: Trailer Lighting Requirements
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Tips for Determining Square Trailer Axle Capacity
- Q&A: 7-Way Trailer Connector For 2021 Jeep Wrangler Without Factory Tow Package
- Q&A: Trailer Hitch Wiring, Hitch and Brake Controller for 2018 Jeep Wrangler JL Unlimited
- Q&A: Installation Instructions For Hopkins Engager Trailer BreakAway Kit
- Q&A: Can Trailer Breakaway Kit be Used without a Battery
- Q&A: Would Could Fix Excess Coupler Play with Demco EZ Latch Coupler