Replacement Trailer Roof Vent Lid Recommendation with Continous Hinge
Question:
Where do you measure from when replacing vent cover. I measured end to end ,the crank bar at 14 1/4 inches. It is a square opening. It has a continuous hinge. Which replacement cover do you recommend?
asked by: Jim M
1
Helpful Expert Reply:
What you described sounds like a standard style of trailer roof vent which we have replacements for.
The part # BV0554-01 has a continous hinge and is most likely what you'd need. Check out the picture I attached to see the hinge style.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Vent Cover for Ventline Old Style Rounded Dome Trailer Roof Vents - White
- RV Vents and Fans
- Replacement Lid
- Roof Vent
- 14W x 14L Inch
- Plastic
- White
- Ventline
more information >
Continue Researching
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Article: Trailer Maintenance Schedule
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Roof Vent Cover for Lid Marked AS-13M-VDO449 ANS Z26 1
- Q&A: Location of Heating Element on Atwood GC6AA-10E Water Heater
- Q&A: Should the Tires Lift Off the Ground While Leveling With the Lippert Ground Control Leveling System
- Q&A: Troubleshooting 6 Gallon Atwood Water Heater Not Working on Electric But Works on LP
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Article: How to Replace an RV Roof Vent Cover
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: RV and Camper Types, RV Classes
- Article: Rooftop Cargo Carriers