bing tracking image
Q & A Icon

Installing the Tekonsha Voyager on a 2010 Chevy Silverado 2500  

Question:

Want right wire system for 2010 Chevy Silverado 2500 had to replace factory system with your product.

0

Expert Reply:

To install a brake controller like the Tekonsha Voyager # 39510 on your 2010 Chevrolet Silverado 2500 you will simply need to splice the wires on the pigtail # 20127 to the following functions:

Black - 12V Power
Blue - Brake Controller Pin on 7-Way
White - Ground
Red - COLD Side of Stop Light Switch (only gets hot when brake pedal is pressed)

Your Chevy doesn't have a factory plug to connect the Voyager to so you will need to cut any connector from your OEM brake controller off and then connect the appropriate wires as listed above.

I have attached a video of this same brake controller being installed on a similar 2010 Silverado for you to check out. Please note that our installer ties off the Orange factory wire.

expert reply by:
0
Jon G

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>