Hole Size Needed to Install LED Trailer Tail Lights w/ Grommet # TLL12RK
Question:
What size hole is needed for these lights?
asked by: Randal
0
Expert Reply:
The hole needed to install the part # TLL12RK will be 6-3/4 inches long by 2-1/2 inches wide.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics Fleet LED Trailer Tail Lights w/ Grommets - Stop,Turn,Tail - Submersible - Oval - Qty 2
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Oval
- Kit
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Is It Better To Carry Bikes Behind Flat Towed Vehicle or Above Tow Bars?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Enjoy The 2024 Eclipse With Harvest Hosts
- Q&A: Replacement Hub And Bearing Kit For An AL-KO 8460 Hub
- Q&A: Recommended Trailer Tail Lights To Replace Older Glo-Brite 9553
- Q&A: Recommended Gauge of Wiring for Trailer Lights
- Q&A: Does Trailer Wiring Harness C56040 Require a Wire to be Run to the Battery on a 2012 Subaru Forester
- Article: Where to Position the Trailer Axle?
- Q&A: What Is The Torque Spec For The 8-288-3UC1 Hub/Drum Assembly
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: Best Way to Protect The Front Of a 2024 Chevrolet Trax When Flat Towing