What Is Needed To Wire Hopkins Agility Brake Controller # HM47294 to a 2004 Chevy Silverado
Question:
2004, Chevy Silverado, 2500HD I just bought this and want to know if I need any wiring kits that run from this break controller to the end of the bed where my trailer would plug into? If I do could you provide me the part number or web link where I could buy it at? Thank you for your help
asked by: Stephen L
Expert Reply:
If you have a factory 7-way trailer connector present at the rear of your vehicle then all you would need to do is attach the harness from the Hopkins Agility Brake Controller w/ GM Adapter, part # HM47294 and # HM47795, to the port that is under your dash and then connect the other end to the brake controller and you would be good to go.
If you do not have a factory 7-way present at the rear of your vehicle you will need to install a Brake Controller 7 & 4 Way Installation Kit, part # ETBC7, and connect a few wires under the hood of your vehicle to complete the install. I attached an FAQ on installing a brake controller on 1999-2006 Chevy trucks for you to check out, as well as installation instructions for the # ETBC7.
Products Referenced in This Question
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >