Troubleshooting Weld Nuts for Hitch Installation on 2006 Toyota Highlander
Question:
I purchased and installed the 75153 max-frame on my 06 Toyota Highlander. However, after removing the plugs that were hiding the treads for the third bolts on each side of the frame. I tried hand screwing in the bolts in that third hole and it doesnt seem to be tightening. So what Ive done for now is Ive secured the four tie down bracket holes. Need help in troubleshooting this. Need to know if itll be okay with just the four or do I need all six bolts in? Will be towing a 17foot bass boat.
asked by: Noah H
Expert Reply:
It is often necessary to clear out the frame weld nuts used to mount a hitch. Especially on vehicles that are a few years old there can be some slight corrosion within the threads on those nuts that can make it tough to get the bolts started. You can refer to the two linked articles for help.
A spray-on lubricant/solvent like WD40 or PB BLaster can help dissolve that rust/grit and make it possible to thread in all of the fasteners included with your Draw-Tite hitch # 75153.
Your hitch will deliver its rated capacity and provide for safe towing only when it is installed according to the manufacturer's instructions, which are also linked for you. Be sure to follow the torque specs for all fasteners that are indicated in those instructions.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Trailer Hitch Recommendation for a 2007 Toyota Highlander Hybrid
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Can Spare Tire Be Accessed After Mounting Curt Class III Trailer Hitch # 13530 on 2009 Lexus RX350
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between the Kuat NV 2.0 and the Older Version of the Rack
- Q&A: Is there a 12 Inch Trailer Tire that is Rated for 80 Miles Per Hour
- Q&A: Trailer Hitch that Fits 2022 Kona N
- Q&A: Best Position for B&W 5th Wheel Hitch in 2014 Ram 3500 Long Bed with Factory Prep Package
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Hitch Receiver Sizes
- Article: Routing the Power Wire for a Trailer Wiring Harness