Load Resistors to Correct Flashing LED Trailer Lights When Connected to Mercedes GL 350
Question:
Wil the electronic flasher fix that that problem
asked by: Jerry V
Expert Reply:
If a vehicle uses standard power-hungry incandescent lighting for its own tail lights and it is connected to a trailer that uses high-efficiency LED type lighting, then it can happen that the vehicle's wiring can have trouble detecting the presence of the connected trailer lights. This can cause what is termed hyperflashing.
When this is the case, installation of load resistors such as # DI34ZR will give the trailer's electrical load the appearance of being incandescent and this often stops confusing the vehicle wiring. One needs to be installed at each affected light.
Products Referenced in This Question
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
Curt 7-Way to RV Socket LED Circuit Tester - Vehicle End
- Electrical Tools
- Testers
- Circuit Tester
- Tow Function Tester
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Flat Towing Set Up for a 2019 Chevy Colorado
- Q&A: Suspension Enhancement Recommendation for 2019 Toyota RAV4
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can a 2019 Chevrolet Colorado 4x4 Be Flat-Towed
- Q&A: Rear Suspension Enhancement For 2024 Toyota RAV4
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: Recommended 7-Way Tester that is Compatible w/ Ram Factory Brake Controllers
- Q&A: Is There B and W Companion Hitch that Fits OEM Pucks of 2023 GMC 3500 Sierra
- Q&A: Will Flat Towed Vehicle Charge Line Kit Prevent Back-Feed and Overcharging?
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Brake Controller Installation: Starting from Scratch