Hardware Needed for Replacing Wobble Rollers on Boat Trailer
Question:
I need to replace all the wobble rollers on a very old boat trailer. I have a couple questions: 1 Are these shafts too rusty to allow the rollers to turn? 2 How important is it that the replacement rollers are exactly the same size? The old ones are 4 3/4inch wide and 4 1/4inch in diameter, but the only rollers I see on your site that fit a 5/8 shaft are 3inch wide and 5inch diameter. 3 What other hardware do I need to order to install the new rollers? Thank you!
asked by: Elizabeth A
Expert Reply:
The shafts in your picture do look a bit rusty but most likely they will still work. But you have to inspect them all to make sure they only have surface rust.
You'll also need the washer part # CE10982 and the retainer ring part # CE10981 to install the wobble roller part # YR530R-5P you mentioned.
Products Referenced in This Question
CE Smith Wobble Roller Washer for 1-1/8" Shaft - Zinc-Plated Steel - Qty 1
- Accessories and Parts
- Boat Trailer Parts
- Trailer Hitch
- Trailer Suspension Parts
- Weight Distribution Hitch
- Hardware
- 1-1/8 Inch Diameter
- Washers
- CE Smith
more information >
Yates Ribbed Wobble Roller - Heavy-Duty Rubber - 5" Diameter - 5/8" Shaft
- Boat Trailer Parts
- Rollers
- Wobble Roller
- 3 Inch Wide
- 5 Inch Diameter
- Black Rubber
- Fits 5/8 Inch Shaft
- Yates Rubber
more information >
Product Page this Question was Asked From
CE Smith Wobble Roller Retainer Ring - Zinc-Plated Steel - Qty 1
- Accessories and Parts
- Boat Trailer Parts
- Hardware
- Retaining Ring
- CE Smith
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Wobble Roller Needed with 1 Shaft for Older Boat Trailer
- Q&A: Troubleshooting A Bouncy Ride On A Vanleigh RV Vilano 325RL Fifth Wheel Trailer
- Q&A: Recommended Replacement Wobble Roller Parts for Venture Boat Trailer
- Q&A: How to Install Wobble Rollers on Older Boat Trailer
- Q&A: Comparing Gen-Y 5TH Wheel To Gooseneck With 1621 Pin Box Lengths
- Q&A: Replacement Wheel Cylinder for EZ Loader Boat Trailer
- Q&A: Comparing Replacement Endcap for Fulton Bolt-Thru Swivel Marine Jacks F500323 and 500323
- Article: Trailer Wiring Diagrams
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Tire Sizing
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: How to Measure for Trailer Hitch Drop
Troy S.
3/25/2020
My current wobble rollers are in need of replacing. The measurements are:1” shaft 3” wide4 1/2 diameterWould you inform me as to what size I can use? Can’t seem to find the above measurements? I have pictures! Need to prefer ASAP!