What Tools are Needed to Install Draw-Tite Trailer Hitch 75751 on a 2006 Ford Escape
Question:
I am installing a 75751 hitch on my daughters 2006 Ford Escape and would like to know what tools I will need since Im travelling from Lac La Biche Alberta flying to Ottawa where her vehicle is and will bring the tools with me. Thanks
asked by: Darcy L
0
Expert Reply:
To install Draw-Tite trailer hitch # 75751 on the 2006 Ford Escape you will need a 10mm, 18mm, 22mm, and 5/8" wrench. You will also need a torque wrench good for at least 115 foot pounds. I have linked a video showing an example installation as well as the instructions for you.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 5250 lbs WD GTW
- 2 Inch Hitch
- 675 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Brake Assemblies and Hub/Drums for 15k Dexter Axle
- Q&A: Recommended Square Bulldog Jack with 5,000 lb Capacity
- Q&A: No Turn or Brake Signals on Trailer on a Jeep Liberty with Tow Ready Harness 118524
- Q&A: Trailer Tire Wear on Right Side, Outside Tread Only and Trailer Pulls Hard to One Side
- Article: Trailer Tire Sizing
- Article: Replacement Automotive Lighting
- Q&A: Replacement Kwikee Electric Steps for a 2005 Jayco Greyhawk 31SS
- Q&A: Best Track System for a Roof Rack on a NuCamp T@G Camper
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Hitch Fit for 2019 Mercedes-Benz Sprinter 2500 with 170 Inch Wheelbase and Standard Bumper
- Article: Determining Trailer Tongue Weight
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches