What Is The Height Of The Powerbuilt Jack With Stand?

Question

Question:

you give a lot of measurements, how tall is the jack its self?, the 21inch lift is in addition to the height of the jack?? thanks

asked by: Michael B

0

Expert Reply:

The Powerbuilt Unijack Bottle Jack with Built-In Jack Stand - 21" Lift - 6,000 lbs # ALL620471 has the integrated bottle jack. This unit is 11 inches tall prior to using the jack and has a lift of 10 inches for the maximum height of 21 inches. I've attached a couple videos to help further.

expert reply by: Jason S

0

Answer 1

The Blaylock Wheel Chock part #EZ-JACK that you referernced should work just fine on a trailer with fenders like yours. I attached a picture that shows it being used on a trailer with fenders for you to check out plus a review video. The overall…

view full answer...

Answer 2

Your axles are so far apart that you would need to go with a bottle jack like the part #ALL620471 to get the axle off the ground high enough to change the spare. I wish there was a ramp style jack that would work but like you figured out the axle…

view full answer...

Answer 3

For a jack to use in an emergency to change a flat tire I recommend using the Powerbuilt Bottle Jack #ALL620471. This jack has a lift range of 11" to 21" and a 6,000 lb capacity which is more than enough for your camper trailer. I've…

view full answer...

Answer 4

You're welcome! The lightest weight wheel tire combo with a ST235/75R15 tire is the Taskmaster ST235/75R15 Radial Off-Road Tire w/ 15" Vesper Silver Mod Wheel item #TA75RR which weighs in at 55 lbs.

view full answer...

Answer 5

Since the Progressive Dynamics 2000 Watt Inverter w/ Transfer Switch #PD64FR is rated for 30 amps you can absolutely use it with a 30 amp service. For powering all your outlets, that would really depend on the wattage requirements of the appliances…

view full answer...

Answer 6

The Hydrastar #HS381-8067 is a vented version of the actuator designed for marine applications (boat trailers) whereas the part #HBA16 was not designed for marine applications.

view full answer...

Answer 7

I reached out to Roadmaster about the Comfort Ride Leaf Spring Suspension Kit w/ Shocks #RM-2460-2580 you are looking to install. While they are unable to give exact numbers for the length of travel on the leaf springs the shocks do have 5-1/2"…

view full answer...

Answer 8

The Air Lift WirelessONE Compressor System #AL25980EZ and Air Lift WirelessONE Compressor System #AL25980 are nearly identical with only some very minor differences in CFM and duty cycle ratings. The #AL25980EZ will also come with an easier mounting…

view full answer...

Answer 9

A leveling jack such as #JSC-24 is not designed to lift your trailer off the ground, it is only meant to provide support to your camper. To change a tire on your trailer you would want to use a bottle jack such as #ALL620471. I've added a link to…

view full answer...

Answer 10

When I reached out to my contact at Powerbuilt they indicated that the hole in the side of the Powerbuilt Unijack Bottle Jack with Built-In Jack Stand #ALL620471 is actually a plug that you need to remove (see attached). This being a plug would help…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

What Is The Height Of The Powerbuilt Jack With Stand?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching