Where to Find Installation Hardware for Yakima Replacement 1-1/4 Inch Tongue for HoldUp Bike Racks
Question:
8880581 Do you sell the Installation hardware?
asked by: Mike
0
Expert Reply:
I spoke with my contact at Yakima regarding the Replacement 1-1/4 Inch Tongue for Yakima HoldUp Bike Racks # 8880581 referenced in your question. She stated that the only additional hardware that will be needed to install the tongue is the existing screws on your HoldUp Bike Rack. You will not need any additional hardware to properly install this replacement part.
This can be used to replace the tongue on the 1-1/4 inch HoldUp Bike Carrier or to convert the HoldUp for 2 inch hitches for use with a 1-1/4 inch hitch.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Replacement 1-1/4" Hitch Shank for Yakima HoldUp Bike Racks
- Accessories and Parts
- Hitch Bike Racks
- Shanks and Adapters
- Shanks
- HoldUp
- Yakima
more information >
Continue Researching
- Q&A: Converting Yakima HoldUp Bike Rack to Use With 2 Inch Hitch
- Q&A: Bolt Sizes for a 2006 Toyota Matrix Trailer Hitch 24812
- Q&A: Is There a Lock Available for Threaded Yakima Hitch Pins?
- Q&A: Replacement Parts for Yakima Dr. Tray Bike Rack
- Q&A: Replacement Hitch Bolt for Yakima HoldUp 1-1/4 Inch Bike Rack # Y02445
- Q&A: How To Convert Yakima HoldUp for 1-1/4 Inch to 2 Inch
- Q&A: Comparing the Yakima HoldUp Original to the Yakima HoldUp EVO
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Hitch Receiver Sizes
- Article: Roof Rack Information
- Article: Trailer Wiring Diagrams
- Article: Hitch Adapters and Extenders