Will the Stromberg Carlson Electric Jack Replace a Jack that has a Triangle Mount Flange
Question:
I am purchasing a 2016 Vengeance 25V toy hauler. It has a triangular three bolt mounting pattern. Will this jack adapt / fit?
asked by: Michael S
0
Expert Reply:
Yes, the Stromberg Carlson Electric Jack, # JET-3555, will fit on your trailer's A-frame jack mounting hole.
A-Frame jacks are all the same size and have the same bolt-pattern. The manufacturers did this so they could simplify the manufacturing process for both bolt-on and weld-on A-frame jacks.
The mounting bolt holes on the Stromberg Carlson jack measure 3 inches from center to center.
expert reply by:
Jared P
0
Product Page this Question was Asked From
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 24" Lift - 3,500 lbs - White
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Best Solution For Gaining Tail Gate Clearance On A-Frame Trailer Tongue Jack
- Q&A: Can Generator Be Ran While Installed on MORryde RV Generator Slide Out Tray
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Q&A: Trailer Jacks Manufactured in the USA
- Q&A: Recommended Weight Distribution System To Tow An ATC Game Changer 2513 Travel Trailer
- Article: Best Camper Jacks
- Q&A: Using Trailer Jacks To Transport A Yakups Kayak Carrier
- Q&A: What Weight Capacity of Tongue Jack is Needed for a 4,600 Pound Dry Weight Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: What is an RV-Approved Bike Rack? (And Do You REALLY Need One?)
- Article: Performance Chips and Modules
- Article: Trailer Jacks
- Article: How to Raise Your Travel Trailer Height