Hook Size of Rack'em Motorcycle Helmut Rack
Question:
I need clarification on the measurements. Your diagram shows the hook 2 inches from the main part measured from the tip yet your description accompanying the diagram refer to it a a 2 inch hook. So is the length of the hook AND the distance of the tip to the main body both 2 inches? My trailer has the ability to put a hook over the top but the outer skin is less than 2 inches from the inner wall as most trailers would be.
asked by: John L
Expert Reply:
I just went out and re-measured the hook of the Rack'em Motorcycle Helmut Rack # RA-22.
The inside length of the hook is 1-1/2 inches and it reaches about 1-1/4 inches from the main upright. It's also about 1-1/4 inches from the top of the upright to the bottom of the opening of the hook on the inside.
Product Page this Question was Asked From
Rack'Em Motorcycle Helmet Rack for Enclosed Trailers
- Trailer Cargo Organizers
- Hooks and Hangers
- Helmet Hanger
- Recreation
- Pre-Drilled Holes
- RackEm
more information >
Continue Researching
- Q&A: Towing Capacity and Weight Distribution for 2017 Jeep Wrangler
- Q&A: 4-Pole Trailer Wiring Harness for 2017 Toyota Tacoma
- Q&A: When Using Bearing Buddy Bearing Protectors Do I Need To Repack Bearings Periodically?
- Q&A: How Much Weight Can the E-Tracks Hold Attached To Plywood
- Article: The Best Towing Mirrors
- Q&A: What is the Wizard Button for on the Progressive Dynamics RV Power Control Center
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Can CargoSmart Motorcycle Wheel Chock for E-Track or be Used with 3 inch Wide Tires
- Q&A: Will Towing Nose High Degrade the Trailer or Do I Need to Lift It
- Article: What To Look For When Buying Ratchet Straps
- Article: How to Install E-Track in 3 Easy Steps
- Article: Determining Trailer Tongue Weight
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Rust Prevention