Replacement 4-Way Connector For Wishbone Trailers
Question:
my utility trailers 4 pole connector needs replaced. The trailer has 5 wires which are brown/green, brown/yellow, two different brown wires and finally the white ground wire. Im pretty sure the green and yellow are turn signals and one brown is the break and one brown is the tail light. I can not find a 4 pole connector that accepts 5 wires. Im attaching of photo of the original 4 pole connector. Can you please help?
asked by: Steve
Expert Reply:
Your utility trailer has a wishbone wiring harness therefore, in order to replace the connector you will need the Quick Fix (TM) 4 Pole Flat Trailer End part # HMC20031. There is an extra running light wire on the wishbone harness that runs down each side of the trailer eliminating the need for a jumper wire.
The Quick-Fix connector is designed to replace your existing 4-way without the need to hardwire or splice any wires. To install, you will need to sever the wires just before your existing connector with an equal amount of length on each end. You will then need to place the corresponding wires into their correct location on the new Quick-Fix. The connector will have two alphabetic symbols next to each attachment point. For example, (gd) is for the ground which is typically the white wire, (TM) is for tail/marker lights which is typically the brown wire, (LT) is for the left turn signal and brake lights which is the yellow wire, and (RT) is for the right turn signal and brake lights which is typically the green wire. Since you have a wishbone trailer wiring harness, you will need to connect both of the brown wires in the same location on the connector in the (TM) slot.
Product Page this Question was Asked From
Quick Fix (TM) 4 Pole Flat Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 4 Flat
- Hopkins
more information >
Continue Researching
- Shop: Quick Fix (TM) 4 Pole Flat Trailer End
- Video: Hopkins Wiring - Trailer Connectors - HMC20031 Review
- Shop: Hopkins Endurance Easy-Pull Y-Harness with 4-Pole Flat Trailer Connector - Trailer End - 20'
- Shop: Hopkins Endurance Easy-Pull Harness with 4-Pole Flat Trailer Connector - Trailer End - 25' Long
- Q&A: How to Determine if a Torsion Axle Needs to be Replaced and Lifting a Trailer Off the Ground
- Shop: Trailer Wiring
- Video: Optronics Trailer Lights A65PB Review
- Video: Fulton Trailer Winch - Standard Hand Winch - F142002 Review
- Video: Optronics Trailer Lights - Clearance Lights - MCL165AB Review
- Video: Dutton-Lainson Trailer Winch - Standard Hand Winch - DL14125 Review
- Search Results: a68pb
- Search Results: 12 inch trailer wheel
- Search Results: side marker light
- Search Results: winch
- Search Results: a65pb
- Search Results: wesbar tail light 3554
- Search Results: winch stand
- Shop: Trailer Clearance or Side Marker Light w/ Reflector - Incandescent - Rectangle - Amber Lens
- Shop: Hopkins Endurance Easy-Pull Harness with 4-Pole Flat Trailer Connector - Trailer End - 12" Long
- Q&A: Can the Ground Wire On the Hopkins Endurance Easy-Pull Harness Be Shortened
- Shop: Piranha Slim-Line LED Mini Clearance or Side Marker Light - Submersible - 2 Diodes - Amber Lens
- Shop: Kenda 4.80-12 Bias Trailer Tire with 12" White Wheel - 4 on 4 - Load Range B
- Article: Trailer Wiring Diagrams
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Shop: Vehicle Tow Bar Wiring
- Video: Dexter Axle Trailer Hubs and Drums - Hub - 8-259-50UC1 Review
- Q&A: What Gauge Wire Is Used On the Hopkins Endurance 4-Way Flat Trailer Wiring Harness?
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Q&A: How Do I Convert My 5 Wire Flat to a 4 Wire Flat
- Q&A: Does Trailer Lighting Ground Through the Hitch Ball