How to Remove the Fluid Caps on the Titan BrakeRite EHB Electric-Hydraulic Actuator # T4813102
Question:
We arent smart enough to get the caps off. Help!
asked by: Todd S
0
Expert Reply:
To remove the caps on the reservoir for the Titan BrakeRite EHB Electric-Hydraulic Actuator for Disc Brakes # T4813102 you will simply turn them counter-clockwise as depicted in the attached picture.
Keep in mind that only DOT 3 brake fluid should be used.
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Dexter BrakeRite II Electric Over Hydraulic Actuator Kit - Vented - 1,500 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- Disc Brakes
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Trailer Wiring Diagrams
- Q&A: Can Control Module on Titan BrakeRite II SD be Replaced
- Q&A: Troubleshooting Titan BrakeRite for Disc Brakes That Wont Power Up
- Q&A: Troubleshooting Dexter Electric Over Hydraulic Actuator that Runs When Disconnected
- Q&A: Is Actuator Available for Titan BrakeRite Plug Play Electric-Hydraulic Actuator Kit?
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Replacement BrakeRite Actuator for Kit with Internal Board Issue
- Q&A: Installing Draw-Tite Brake Controller On 2005 Chevrolet Silverado
- Article: How to Replace or Install an RV Roof Vent
- Q&A: Does the Titan BrakeRite Electric-Hydraulic Actuator Plumb into Hydraulic Trailer Brake Lines
- Article: How to Raise Your Travel Trailer Height
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: 2023 Best Gifts for Outdoor Enthusiasts
Michelle L.
7/28/2020
Does etrailer sell replacement caps for this unit?