Trailer Wiring Connection Points for a 2010 Cadillac CTS Wagon
Question:
My installer can not locate where driver side wiring access is for light wiring for trailer hitch.
asked by: Craig M
Expert Reply:
The correct wiring for a 2010 Cadillac CTS is the Tow Ready Custom Fit Vehicle Wiring, # 46255. The connection points for this harness are located behind each of the tail light assemblies. In a sedan, you would pull back the trunk lining to gain access to the back of the tail lights. But on a wagon, either the tail light assemblies will need to be removed or there may be an access panel in the cargo area that needs to be taken off in order to reach the connection points.
I have included a link to the installation instructions and a video showing a typical installation for you to view.
Products Referenced in This Question
Hopkins Active Tail Light Converter with Install Kit
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug and Lead
- 4 Flat
- Hopkins
more information >
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Hitch Fit For 2019 Mercedes-Benz E-300 and E-400
- Q&A: Can Curt Hitch Extender part # C45048 Fit Into Factory Hitch of 2003 Dodge Ram 2500
- Q&A: Can I Replace 8-14.5 Tires with a Non-Metric Sized Tire
- Q&A: Best Replacement Option for 8-14.5 Trailer Tires
- Q&A: Trailer Hitch Recommendation for a 2010 Cadillac CTS
- Q&A: Can a Cadillac CTS-V Tow a Trailer
- Article: Best Bike Racks for Electric Bikes
- Article: My Trailer Hitch Doesn't Fit
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: How To Determine the Weight Capacity For a Trailer Axle
- Article: What Do I Need To Tow A Trailer?
- Article: How to Choose the Right Trailer Hitch Class