Installing the Tekonsha T-One Wiring Harness on a 2016 Honda CR-V

Question:

Hi, I have a 2016 Honda CRV. I am planning to install this wiring harness. Kindly provide the complete list of tools needed for this install. Please include the details of the electrical device used to test the signal after installation. Thanks

asked by: Prax

Helpful Expert Reply:

The Tekonsha T-One Wiring Harness # 118561 lists in the installation instructions the tools required to install this wiring harness on your 2016 Honda CR-V.

The instructions list includes:
Trim Panel Remover, 10mm Socket &
Ratchet or 10mm Wrench, Drill (3/32” Drill Bit),
1/4” Socket, Wire Crimpers, Wire Cutters,
Philips Head Screwdriver, Test-probe.

The circuit tester probe that I recommend is # PTW2993. This circuit tester will allow you to test each pin of the 4-way trailer after installation. The attached video will show you how the tester is typically used during this test.

The installation instructions for the T-One harness can be accessed using the link towards the bottom of this page. I also attached an installation video of the T-One wiring harness being installed on a 2016 Honda CR-V for you to review.