Troubleshooting Brake Controller Displaying S.H Error Code
Question:
What does s h mean
asked by: Richard A
Expert Reply:
A display of S.H on a brake controller indicates the controller is detecting a short on the brake output circuit during idle (non-braking) conditions.
There is a short in the brake output wire(Blue) between the brake controller and the brake assemblies. This can be caused by bent or damaged pin in the trailer connector or corrosion. Check the trailer connector on both the vehicle and the trailer. If that all checks out, start checking the wires from the trailer connector to the brake assemblies on the trailer. Look for cuts, pinched or damaged wires causing the problem.
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Most Popular Wheel Bearings
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Q&A: Parts Needed to Install 7-Way/4-Way on 2024 Kia Telluride with LED Taillights
- Q&A: Lift Kit Options For A 2015 Winnebago Micro Minnie 1706FB
- Q&A: How Is Spring Bar Tension Set Up with Trailer Weight Distribution System
- Q&A: How do I Tell if the Brake Controller is Bad