Could 5-Way of 5-Way to 7-Way Adapter be Removed and Wired to Trailer Wiring
Question:
I have a 5 pin flat boat trailer wiring harness and I have to use the converter to the 7 pin to fit my F350 to tow it. Can I match up the colors of wires from the 5 pin flat to the function on the 7 pin round and do away with the 5 pin? Thank you
asked by: Mark V
0
Expert Reply:
Yes, if you wanted to just remove the 5-pin on your trailer as well as on your adapter you could wire the 7-way left over to the wiring of the trailer.
If the colors are the same on the trailer wiring side as what the pins correspond to on the adapter's wiring then you could match them color by color.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Adapter 7 Pole to 5 Pole Flat Wired Adapter
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 0 - 5 Feet Long
- 7 Round - Blade
- Plug and Lead
- 5 Flat
- Optronics
more information >
Continue Researching
- Q&A: Replacement Hub And Bearing Kit For An AL-KO 8460 Hub
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended E-Z Lube Hub and Rotor Assembly for 6K Axles
- Article: Cargo Tie-Down Methods
- Q&A: Does Trailer Wheel Hub/Brake Drum Need to Be Replaced if Inside Surface is Grooved
- Q&A: Boat Guide On For a Karavan Boat Trailer With 2" X 5-1/2" Frame Rails
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Replacement 5-Way Connector for Ranger Boat Trailer
- Q&A: Replacement Hub/Rotor and Bearings for Tie Down Engineering TDE46245
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class