Where To Connect The Tow Ready T-One Wiring Harness # 118490 On A 2010 Volkswagen Routan
Question:
Does the 2010 Routan have pre wired connection point for the trailer plug
asked by: Tom C
Expert Reply:
To install the Tow Ready T-One Wiring Harness, part # 118490, on your 2010 Volkswagen Routan you will plug the T-One connectors into the back of your tail light connectors. The T-One connector with the yellow wire will plug into the back of the tail lights on the drivers side and the T-One connector with the green wire will plug into the back of the tail lights on the passenger side.
The separate white wire will need to be grounded to a good, clean piece of metal like the vehicle frame.
The only remaining thing to do is to run the 4-flat trailer connector through a grommet in the jack storage area.
I am including a link to the installation instructions on the Tow Ready wiring harness.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: My Trailer Hitch Doesn't Fit
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Q&A: How To Add A 7-Way To a 2010 Volkswagen Touareg With Plug Under Rear Bumper
- Q&A: Recommended Trailer Wiring for a 2015 Dodge Grand Caravan
- Q&A: Is Transmission Cooler Needed When Towing With 2015 Dodge Grand Caravan?
- Article: Performance Chips and Modules
- Q&A: Trailer Hitch Fit and Towing Capacity for a 2014 Volkswagen Jetta SportWagen
- Q&A: Availability of 2 Inch Receiver Hitch for 2014 Volkswagen Jetta TDI
- Q&A: Is Installation Of Wiring Harness On 2013 Volkswagen Tiguan Difficult
- Q&A: What is Towing Capacity of 2014 Chrysler Town and Country