Fender Back Recommendations for a Trailer Fender # HP29VR
Question:
Do they make a fender back that will fit a F1075x32-1R fender.
asked by: Scott P
0
Expert Reply:
Yes, you could use a Pre-Cut Fender Back for Redneck Trailer Fender, part # 10FB-32R.
Or if you wanted a fender back that is slightly wider you could get a Pre-Cut Fender Back for Redneck Trailer Fender, part # 12FB-32R.
expert reply by:
Jameson C
0
Products Referenced in This Question
Pre-Cut Fender Back for Redline Trailer Fender F9X32-1R - 10-1/2" Wide
- Accessories and Parts
- Trailer Fenders
- Fender Back
- 10-1/2 Inch Wide
- 29-3/4 Inch Long
- Redline
more information >
Pre-Cut Fender Back for Redline Trailer Fender F9X32-1R - 12" Wide
- Accessories and Parts
- Trailer Fenders
- Fender Back
- 12 Inch Wide
- 30 Inch Long
- Redline
more information >
Product Page this Question was Asked From
Single Axle Trailer Fender for Enclosed Trailers - Cold Rolled Steel - 15" Wheels - Qty 1
- Trailer Fenders
- No Step
- 15 Inch Wheels
- 10-3/4 Inch Wide
- 32 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Trailer Fender Close to 29-1/2" Long, 13" Tall & 9-1/2" Wide
- Q&A: Availability of 11 x 32 x 15 Inch Fenders for Single-AxleTrailer
- Q&A: Recommended Replacement Fender For A 2018 Forest Rover R-Pod RP-179
- Q&A: Trailer Fender Installation Clearance and Mounting Project
- Q&A: Parts Needed To Flat Tow New 2021 Ford F-150
- Q&A: Trailer Hitch Recommendation for a 2010 Cadillac CTS
- Q&A: Recommended Trailer Tire/Wheel to Provide Smoothest Ride Quality for Delicate Cargo
- Article: Where to Position the Trailer Axle?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision