Can Bulldog Front Bumper BDW21000 Fit 1997 Jeep Wrangler and be Flat Towed  

Question:

Expert Reply:

Yes you can use the Bulldog Stubby bumper # BDW21000 for flat towing your 1997 Jeep Wrangler. After installing the bumper you will just need the right components to flat tow the Jeep using the bumper. You will need brackets # BX88357 and a compatible tow bar. I recommend the Alpha, # BX7380, since it is rated for 6,500 pounds and comes with safety cables.

For lighting you can use the diode kit, # RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies of the towed vehicle. This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV.

And finally, most states now require supplemental braking in the vehicle being flat towed. The easiest system to set up and use is the Blue Ox Patriot # BLU37TR, that applies the vehicle brakes in proportion to how much the tow vehicle is braking. This is the safest way to stop and it reduces wear and tear on both vehicles.

Most likely you will also need a high low adapter so that the tow bar will be level when you are flat towing. I attached a link to a page that has all of the ones we carry.

I have included a couple of helpful links to our articles on flat towing for you. Be sure to consult the vehicle owners manual for more specific information on flat towing your vehicle.

expert reply by: Jameson C

0