Class IV/V 2 Inch Trailer Hitch for a 2010 Ford E-350 Cab and Chassis Van
Question:
My frame is 41and 1/2 inch wide. Need a 2inch receiver, Class IV or V hitch rated for 10,000 lbs. Probably about 8inch
asked by: Gene T
Expert Reply:
On your cab and chassis 2010 Ford E-350 van measure the distance from the center of a bolt hole (where the hitch mounts, see linked instructions) to the center of the same hole on the opposite side. If that distance is 38-5/8 inches then you can install Draw-Tite trailer hitch # 41945. This is a Class IV/V hitch with a 2 inch receiver. I have linked a video showing an example installation for you.
I also recommend etrailer ball mount kit # EBMK2216. It comes with a ball mount with a 1 inch rise or 2 inch drop, 2 balls, a hitch pin with clip, and a storage bag. If the ball mount kit does not have the right rise or drop to tow the trailer level, use the link I have included that explains how to measure to choose a ball mount to tow the trailer level.
For trailer wiring I cannot say for certain if any of the wiring harnesses for models without a factory tow package will fit on the cab and chassis models. It all depends on if it has the same tail lights as the regular van models or not. If it does then you can use # 118551 to add a 4-Way flat to the rear of the vehicle. But if the tail lights are different then I recommend a hardwire kit, # C59496.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Draw-Tite Ultra Frame Trailer Hitch Receiver w/ Cast Center - Custom Fit - Class V - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class V
- 1500 lbs TW
- 10000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Curt Powered Tail Light Converter w/ 4-Way Flat Trailer Connector and Install Kit
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- 8 Feet Long
- Universal Fit
- 4 Flat
- CURT
more information >
etrailer Ball Mount Kit - 1" Rise or 2" Drop - for 8,000 - 16,000 lb Hitches
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- 2 Inch Ball
- 2-5/16 Inch Ball
- Two Balls
- Steel Ball
- Steel Shank - Gloss Black
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 16000 lbs GTW
- Class IV
- Ball Mount Kit
- etrailer
more information >