2013 Honda Odyssey Traction Light On with Tekonsha Voyager 39510 Brake Controller Installed
Question:
Hi, I bought the ETBC7 kit from etrailer to use with my Voyager XP controller on my 2013 Odyssey minivan. The install went perfect thanks to your video and everything seems to work great. THe only issue is now the traction light and check engine lights are both on and I have no idea why. There were 2 teal wires on the break switch that lit when the pedal was pushed - did I tap the wrong one? Otherwise I have the controller grounded to the negative terminal on the battery and, again, everything functions perfectly. Thank you for any assistance!
asked by: Jim
Helpful Expert Reply:
Since your Voyager brake controller # 39510 is operating correctly it is likely that the dashboard error messages you're seeing could be due to an incorrect wire used for the input signal. The # ETBC7 kit you purchased includes a circuit tester that allows you to test each wire at the pedal to find the ONE wire that goes hot ONLY when the pedal is pressed and at no other time.
Auto makers can change wire colors without notice so testing is really the only truly good way to find the correct wire to connect to a brake controller's red input signal wire. Again, the right wire is the ONE that carries a 12V signal ONLY when the brake pedal is pressed and at no other time or with any other vehicle function engaged. This is shown in the linked video at the 7:00-minute mark.
On this particular 2014 vehicle the brake pedal wiring had only one teal wire. You can still test the other teal wire you found (without disconnecting anything) to see if it shows power at different times than the other wire you used for installation.
Product Page this Question was Asked From
Tekonsha Voyager Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Manual Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- Indicator Lights
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Article: Best Camper Jacks
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)