Are Wires Connected to Replacement Switch # LG-145236 with Spade Terminals
Question:
Does the LG-145236 switch have spade connectors on the back so that I dont have to replace the whole wiring harness also? I appreciate the help and look forward to hearing back from you.
asked by: Jim A
0
Expert Reply:
I went out to the warehouse and inspected a Replacement Switch # LG-145236. The wires on the back of the switch do indeed attach with spade connectors. But you have to remove the protective heat shrink covering around it to access the back of the switch.
expert reply by:
Michael H
0
![Michael H](https://images.etrailer.com/static/images/catg/people/324_tn.jpg)
Product Page this Question was Asked From
Replacement Switch for Stromberg Carlson Electric Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Switches
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Choose Replacement Landing Gear for 5th Wheel Trailer
- Q&A: Atwood 87701 landing gear switch replacement
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: Troubleshooting Powered Landing Gear That Won't Operate Under Load
- Q&A: Comparing Air Lift Loadlifter 5000 and Firestone Ride-Rite Air Helper Springs on 2018 Toyota Tundra
- Q&A: Solution for Needing Replacement Atwood Slide Out Switch AT141-134
- Q&A: Stromberg Carlson Landing Gear Replacement for 2001 Fleetwood Prowler LSI 30 5G
- Article: What Size Generator Do You Need to Run an RV Air Conditioner?
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Wiring Diagrams
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Trailer Lighting Requirements
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: What are the Common Types of Propane Fittings Used on RVs?