Will Titan Zinc-Plated Brake Actuator # T43397007K on a 4 Inch Long Tongue 3 Inches Wide
Question:
Im replacing a welded-on actuator on an old boat trailer. After grinding off the old actuator I only have 4inch of clear tongue on which to mount a new part. Will this work for me? Thank you in advance.
asked by: Eric
0
Expert Reply:
The mounting hole spacing for Titan Zinc-Plated Brake Actuator # T43397007K is 3 inches on center. Since you have 4 inches it will work! I have included a link to a video review of this product for you.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Dexter Zinc-Plated Brake Actuator - Drum - Multi-Fit Ball - Bolt On - 7,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Bolt-On
- 7000 lbs GTW
- 1-7/8 Inch Ball Coupler
- 2 Inch Ball Coupler
- Drum Brakes
- No Lockout
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Replacement Drum Brake Actuator for a 1995 4 Winns Model 3916 Trailer
- Q&A: Replacement for Atwood Surge Brake Actuator 82541
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Can the Replacement Atwood Master Cylinder 85736 Still Be Obtained
- Q&A: Surge Brake Actuator Recommendation to Replace Fulton A60 on Trailer
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Q&A: How to Convert a Trailer with Surge Brakes to Electric Over Hydraulic Brakes
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)