Will Pro Series Jack # PS1400300303 Fit Trailer Frame of 2 inch by 3 inch
Question:
So the bolt-on bracket for the jack is adjustable? It can fit a 2inch wide by 3inch tall trailer frame? I see it says up to 3inch x 4inch but my questions is if it will adjust down to 2inch x 3. Thanks.
asked by: J L
0
Expert Reply:
Yes, the frame bracket of the Pro Series jack part # PS1400300303 can easily adjust to fit a 2 inch by 3 inch trailer frame like what you have. The brackets have several holes that can vertically handle varying heights and the threads of the bolts are long enough to allow it to fit thinner frames as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pro Series Round, Snap-Ring Swivel Jack - Bolt On - Topwind - 10" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 10 Inch Lift
- Bolt-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: Dimensions Of The Replacement L-Pin For Equal-i-zer 4,000 Pound WDS
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Q&A: Why Does My Brake Controller Light Stay On After Vehicle is Turned Off
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Does etrailer Bolt-On Swivel Mounting Plate Fit Jack TJP-5001S-B
- Q&A: Load Range D ST205/75R14 Trailer Tire With Galvanized Steel Wheel & 5 on 4-1/2 Bolt Pattern
- Q&A: Looking for a Bolt-On Jack That is Less Than 11 Inches When Attached
- Q&A: Will the Pro Series Round Snap-Ring Swivel Jack Bolt on a 2 Inch Trailer Tongue
- Article: How to Measure a Trailer Axle
- Article: Best RV Roof Vents
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings
- Article: Trailer Jacks
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)