Troubleshooting Powered A Frame Jack that Light Partially Illuminates after Rain
Question:
I have a 1817941 toung jack I noticed the leds on it were on and switch is in the off position. The light brighten up when I turn the switch on. It did thunderstorm last night. What should I do? Thank you
asked by: Marty L
0
Expert Reply:
Sounds like a little moisture got in the switch and is allowing the circuits to partially complete and activate the light. There was another powered jack that had a similar issue. What you need to do is dry out the jack totally and the problem should disappear. A blow dryer will help speed this up but be sure not to go too hot as you might melt something.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Q&A: Hitch Extender For 2-1/2 Inch Hitch For Weight Distribution
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Replacement For A-Frame Tongue Jack on Lippert Electric Ground Control TT
- Article: RV Pre-Departure Checklist
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Article: Trailer Wiring Diagrams
- Q&A: Correct Replacement for an Atwood Water Heater GC6AA-9E
- Article: Trailer Jacks
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Most Popular Wheel Bearings
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Trailer Hitch Drop