Recommendation For Tandem Axles Using Andersen Camper Wheel Chock and Leveler
Question:
I just purchased a set of the Anderson Camper Levelers for my Rockwood fifth wheel camper. I had to cut nearly 4 inches off one of the levelers to fit it between the tires which are by the way 2 1/2 inches apart. My question is, since I cut one leveler off should I cut the other one to match, or leave it full size? Thanks
asked by: Lane K
Expert Reply:
I recommend leaving your second Andersen Camper Wheel Chock and Leveler # AM3604 full size so you will have the most versitility. You can see a similar application in the customer photo found on this page. With that close an application, I recommend starting with your rear tire, then adding the second one in between tires as you start the incline on the ramp. This will give you a little more of an even application.
Product Page this Question was Asked From
Andersen Camper Wheel Chock and Leveler
- Wheel Chocks
- Wheel Chock
- RV
- Trailer
- Plastic
- Single Chock
- Red
- Andersen
more information >
Continue Researching
- Q&A: How to Convert HappiJac Manual Jacks to Electric
- Q&A: Will A Hellwig Sway Bar Fit A 2023 Ford F-350 With A TorkLift SuperHitch Installed
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Best Trailer Hitch for a 2024 Subaru Forester
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Q&A: Will the Hellwig Adjustable Big Wig Rear Sway Bar fit a 2024 Chevy Silverado 3500?
- Q&A: Using Andersen Camper Leveler # AM3604 on Tandem Axle Trailer with Closely-Spaced Wheels
- Q&A: Does a Trailer have to be towed Level or Can it be Off Up or Down
- Q&A: Stabilus Gas Strut 654150 Replacement
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size