Measuring Feet On Reese Square Tube Slider That Are Difficult Installing In Base Rails

Question:

Can this be adjusted or is this a fixed position? I had the hardest time lining up to base rails. pg 5 fig 12. thank you.

asked by: David C

Expert Reply:

There are no adjustments that can be done to the bolted on feet on the bottom of the Reese Square Tube Slider, part # RP30048.

You can check the measurement of the feet to make sure they are square and located correctly. Measure from the front left to the rear right foot and the right front to the rear left. They should have the same measurement within about 1/8 inch. You can also measure the base rails to make sure they are square as well.

expert reply by: Jeffrey L