Where is the Factory Brake Controller Wiring Harness on the 2011 Ford E250

Question:

ORDERED #22290 CABLE FOR 2011 E250FORD VAN PRE-WIRED FOR TRAILER. END DOES NOT MATCH CONNECTOR TAPED TO WIRING HARNESS UNDER DASH SUPPLIED BY FORD

asked by: GARY G

Expert Reply:

It sounds like you may have found the wrong harness on your 2011 Ford E250 Van. I spoke with my contact at Tow Ready and he informed me that you will be looking for a port under the dash, near the top of the instrument cluster, on the back of a panel, it will be slightly to the right underneath the dash, to plug the Tekonsha Wire Replacement for Ford Super Duty Pickups, part # 3034-P into.

If you do not have a brake controller picked out already I would recommend the Tekonsha Prodigy P2 Brake Controller - Proportional, part # 90885. I have attached installation instructions below as well as a video of a # 90885 being installed onto a similar vehicle as yours

expert reply by: Jameson C