Compatibility of the Pro Series 5th Wheel Slider With The Reese 5th Wheel Trailer Hitch 16,000 Lbs
Question:
I have a Reese 30047 hitch and want to know if the 30092 will fit in the rails in my truck bed without having to move one of them.
asked by: Tommy A
Expert Reply:
According to the installation instructions for the Reese 5th Wheel Slider With Rollers, # RP50024, as long as your bed rails are 21-15/16 inches apart from center line to center line of the rails and the rails are properly installed, the Pro Series hitch will work for your application.
The head of your current Reese 5th wheel can be installed on the Pro Series sider. Once, installed the Pro Series slider will give you 10 inches of travel from front to back on your 5th wheel hitch.
A minimum 13 inch extender trailer pin box is recommended. If using a slider, hitch will not adjust to lowest height setting.
I have included an installation video of this hitch on a 2012 Chevy Silverado for you to review.
Product Page this Question was Asked From
Reese 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
- Fifth Wheel Hitch
- Fixed Fifth Wheel
- Aftermarket Below Bed Rails
- 4000 lbs Vertical Load
- 16000 lbs GTW
- Double Pivot
- Standard - Double Jaw
- 13-1/2 - 17 Inch Tall
- Reese
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Ram Trailer Tow Prep Package
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Proper Replacement for Reliable ACT-7.5K Brake Actuator
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Article: Fifth Wheel Hitch Combinations for Ram Trucks with RamBox (2009-Current)
- Q&A: Are Capture Plates Needed When Using the Demco Autoslide With a Lippert Road Armor Pin Box
- Q&A: Troubleshooting Error Retract Timeout on LCI RV Levelers
- Q&A: Where is Brake Controller Install Port for 2018 Ford Explorer
- Q&A: Do all Fifth Wheel Rails have the Same Dimensions