How to Determine the Correct Sidewind Gear Kit to Replace Roll Pins for Gears in a Bulldog Jack
Question:
I had one of roll pins shear off and just want to make sure this is the correct kit. Its a bulldog 190 series with a label number of 015777 and a max weight of 7000 lbs. The pin measures an 8 in standard scres or 4 milleleters.
asked by: Steve
Expert Reply:
There are two possibilities for your Bulldog Trailer Jack. The Replacement Sidewind Gear Kit, item # BD5002581360, is designed for jacks with a 5/8 inch diameter inside bottom gear.
The Replacement Sidewind Gear Kit, item # BD500156, is designed for jacks that have a 1/2 inch inside bottom gear.
You will need to measure the overall diameter of the bottom gear of your jack to get the correct kit.
Product Page this Question was Asked From
Replacement Gears for Bulldog Sidewind Trailer Jacks with 5,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- Bulldog
more information >
Continue Researching
- Q&A: How To Mount The Furrion Chill Replacement For RV Air Conditioner for Dometic Brisk Setup
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: What Is The Thickness Of The Replacement Gear Kit For Etrailer And Ram Sidewind Jacks
- Q&A: Seal With Dimensions to Replace 171255UC
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How to Pick Out Replacement Hub for UFP Hub Marked H-1377 A4E
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Q&A: Installing Brake Controller on a 2007 International 4400 Truck
- Q&A: How to Determine the Correct Leaf Springs for a 2017 Grand Design 5th Wheel with 6,000lb. Axles
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Jacks
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule