What are the Wire Functions on Electric Trailer Brakes
Question:
There is 2 wires for my brakes. Does 1 go to. S and other to ground
asked by: Tim
0
Expert Reply:
On electric trailer brake magnets one wire is ground and the other wire is the power wire. It does not matter which is which because modern brake magnets are not polarity sensitive.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Pollak 6-Pole, Round Pin, Trailer Wiring Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Master Cylinder And Shock For UFP A-60 / A-75 / XR-84 Surge Brake Actuators
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Does B and W Gooseneck Hitch # BWGNRK1217 Fit 2017 Nissan Titan XD Long Bed
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Q&A: Can Sway Control Be Used on a Trailer that Uses a Pintle Hitch Set Up
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: Replacement Master Cylinder for Titan 60ZX7000 Drum Brake Actuator
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Choose a High-Low Adapter
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch