What is the Retracted Height of Fulton F2 Marine Trailer Jack F1413230134
Question:
Can you tell me the retracted height of the Fulton F2 swing-up jack w/ pivoting footplate measured from the center of the mounting bracket? Thanks in advanced.
asked by: Steven S
Expert Reply:
I spoke with my contact at Fulton, and the retracted height of the # F1413230134 jack from bottom of foot to center of mounting plate would be 5-3/8 inches when the bracket is at the lowest setting. When the bracket is slid to the highest setting, the distance would be 18-11/16 inches. The mounting bracket has 13 inches of adjustability, which will give you some flexibility to match the height of the jack to your particular trailer frame.
![Sarah L](https://images.etrailer.com/static/images/catg/people/190_tn.jpg)
Product Page this Question was Asked From
Fulton F2 Swing-Up Jack w/ Pivoting Footplate - 4"-5" Frames, Sidewind, Bolt On - 2,000 lb
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Alloy Aluminum
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Round Foot
- Fulton
more information >
Continue Researching
- Q&A: Will Using 2 of the Timbren Axle-Less Trailer Suspension Kits Double the Capacity?
- Q&A: Bearings and Seal for Replacing UFP Dexter 41062 Hub with Kodiak Hub and Rotor
- Q&A: Will a 5,000 lb Trailer Jack be Easier to Crank than a 2,000 lb Jack
- Q&A: Recommended Trailer Jack For Aluminum Trailer With 5-1/2 Inch I-Beam Frame
- Q&A: Dimensions Of Mounting Plate For Xtreme Off-Road Swing-Up Trailer Jack # ORJW750BD
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Replacement Trailer Jacks for Existing Fulton Weld On Mounting Bracket
- Q&A: Lug Nut Torque Rating for a 5-Lug Trailer Wheel
- Article: Harvest Hosts
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Trailer Jacks
- Article: How to Measure for Trailer Hitch Drop
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub