Retracted Height of Stromberg Carlson Electric A-Frame Trailer Jack JET-3555

Question

Question:

Which of the 12volt a frame jacks have the shortest retracted length?

asked by: Steve O

1

Helpful Expert Reply:

Based on a review of our manufacturer specs the shortest retracted length among the electric a-frame jacks we offer comes from the 3500-lb-rated Stromberg Carlson Electric Trailer Jack # JET-3555. Since it can happen that a manufacturer may alter product dimensions slightly between production runs, I went to our warehouse and measured one of these jacks myself so that I could be absolutely certain of the retracted length dimension of the # JET-3555.

When the inner tube is fully retracted and the drop leg is at its shortest possible adjustment point the bottom of the jack foot plate will be 8-7/8-inches below the bottom of the round mounting flange that contacts the trailer frame. This is shown in the linked photo I prepared for you.

expert reply by: Adam R

1

click to enlarge

Answer 1

According to several measurements we have taken of the electric jack, #JET-3555, from the top of the jack motor housing to the bottom of the housing measures 10-1/2 inches. Then from the bottom of the housing to the mounting plate it measures 10-3/8…

view full answer...

Answer 2

If you're wanting to replace your ShurFlo 2088-403-444 then the Flow Max RV Fresh Water Pump #LC689052 would be a great replacement. It has a 3.0 GPM and a rating of 50 PSI, which will give you a slightly better performance than your SHURflo…

view full answer...

Answer 3

The 052-003-00 number on your current shock is the part number from Dexter Axle. We don't carry the direct replacement but if the specs match for the Lippert Standard Replacement Shock #LC283271 and the axle this is being applied to is a…

view full answer...

Answer 4

To find the correct replacement flange for your trailer you'll first need to remove your current flange to see exactly how it was attached. Your current flange could be screwed onto the pipe or glued to it so you'll need to find out which…

view full answer...

Answer 5

You'll need to chose a jack whose capacity is greater than the fully loaded and ready to tow tongue weight of the camper. Going with a powered jack whose capacity is much greater than the tongue weight of the camper is recommended because the…

view full answer...

Answer 6

It will indeed work; I just checked with Lippert for you and was able to verify the correct toggle switch for your Lippert Power Stance Electric Trailer Jack #LC69VR (which is the 813748), is the following: - Replacement Extend/Retract Switch for…

view full answer...

Answer 7

The correct 12-volt Replacement Gear Motor with Pinion Gear you need for the lid mechanism on your Ventline model V2119 is part #BVB0601-00. For a replacement lid in smoke you can use part #BVD0449-A03.

view full answer...

Answer 8

I checked with my contact at Ventline and for your PR-8 100-CFM range hood the correct replacement motor is the part #BVD0278-00. Then for the fan blade you will need part #BCD0409-00.

view full answer...

Retracted Height of Stromberg Carlson Electric A-Frame Trailer Jack JET-3555

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching