Dimensions Of Stromberg Carlson RV Exterior Ladder Rung End Cap
Question:
Will the RV ladder end cap for a Stromberg Carlson ladder 8540-CP also work on a RV ladder manufactured by Kemberly Inc.? The photograph of this part looks identical to the Kimberly part that I took off my RV.
asked by: A. J
0
Expert Reply:
I cannot confirm that the Replacement Plastic Ladder Rung End Cap on Stromberg Carlson RV Exterior Ladder - Qty 1, # 8540-CP will fit your Kemberly Inc. RV ladder. However, the rough measurements are 2 inches in length by 5/8 inch wide and 1 inch deep. With this being a contoured piece, the measurements are close and hopefully enough for you to determine if it will fit or not.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Replacement End Cap for Stromberg Carlson Exterior RV Ladders - Qty 1
- Accessories and Parts
- RV Ladders
- End Caps
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacement Control Board for Fan-Tastic Vent 7350 Series
- Q&A: Correct Replacement for Glo Brite Marker Lights 118A and 117R
- Q&A: Recommended Replacement Interior RV LED Light for Above Kitchen Sink
- Q&A: How to Tell if Trailer Has 6-Way or 7-Way Installed
- Q&A: Right Turn Signal and Brake Light Not Working
- Q&A: Direct Replacement Converter for Parallax/Magnetek 6345 RV Power Converter
- Q&A: Magnetek Series 6300A Model 6332 Replacement Converter
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Flat Towing Package for 2019 Jeep Cherokee
- Article: My Trailer Hitch Doesn't Fit
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: The #1 RV Roof Maintenance Tip: Keep it Clean (Here's How)
- Article: How to Install E-Track in 3 Easy Steps