Availability of Trailer Ramp Springs to Fit 1-1/2 inch Diameter Shaft
Question:
I have a box truck that I have made a dovetail for. It has 2 155 lb split ramps for loading lawn care equipment. I would like to use a 1.5 pin for the ramps. How many and which Springs should I order for this application
asked by: James E
1
Helpful Expert Reply:
Since you have a 1-1/2 inch diameter shaft you would need the part # RS16933LH for the left hand side and then part # RS16933RH for the right hand side. These have plenty of torque to make lifting either of the ramps very easy.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Trailer Ramp Springs
- Single Ramp Spring
- Left Hand Spring
- 11 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Boat Trailer Seal for a NOK AD2527E Grease Seal
- Q&A: Can Trailer Tire Size 175/80-13 Replace Size 185/80R13
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Choose Safety Chains for 12,000 lb Trailer
- Q&A: Determining Axle Length for 6 Foot 6 Inch Wide Trailer
- Q&A: How Do the Heavy Duty Ramp Springs Install on a Trailer and Ramp
- Q&A: Trailer Tire and Dual Wheel Recommendation for 10K Dexter Axle
- Article: Best RV Roof Vents
- Q&A: Replacement Grease Seal for Dexter 010-054-00 Seal
- Article: Trailer Wiring Diagrams
- Article: Trailer Maintenance Schedule
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure for Trailer Hitch Drop